G10 Pneumatic Pick
Instruction
G10 pneumatic pick is suitable for drilling in mine, crushing incompetent bed, concrete and clay, destroying hard or frozen stratum and other athletics occasion which need impact.
Technical Specification
Total Length 575mm
Weight 10.9kg
Rammerweight 0.9kg
Rammer dia 38mm
Rammer stroke 155mm
Air pressure 0.63Mpa
Impact energy 43J
Impact frequency 16Hz
Air consumption 26L/s
Air pipe inner dia 16mm
Drill 500mm
Maintenance
Pneumatic pick is a exactitube tool that make reciprocating impact, should pay attention to maintenance.
Please abide the following maintenance rules.
1, Air pipe inner dia is 16mm and length is not excess 12 m, the air pressure should be kept at 0.5-0.6Mpa, and keep air pipe clean and fasten hose nipple.
2, When assembling machine, check clearance between drill shank and fixing sleeve, hold handle and force pressure to it slowly, ensure that work normally.
3, Working regularly, oil machine through the pipe connecter every 2-3 hours(3-4.5° E50 turbine oil)
4, Do not insert the whole machine into ledge, when drilling incompetent bed.
5, When machine was jammed in crevice, do not draw out it powerfully, it will damage machine.
6, If dirty block strainer, romove it. Don't take off strainer.
7, When using machine, dismantle it at least twice a week, use diesel oil to clean and dry, then oil, later assemble and operate machine.
8, If machine should stop for along time, dismantle and clean it, then oil and keep in storehouse.
G20 Pneumatic Pick
Instruction
The G20 pneumatic pick is suitable in the mining industry to interrupt the coal bed and to destroy the soft ore; Or in civil engineering and underground construction, .
Specification
Length 572mm
Weight 20kg
Rammer dia 40mm
Rammer stroke 165mm
Impact energy 60J
Impact frequency 16Hz
Air consumption 23L/s
Air pipe inner dia 16mm
Pick drill 450-600MM
Maintenance
1, Air pipe inner dia is 16mm and length is not excess 12 m, the air pressure should be kept at 0.63Mpa, and keep air pipe clean and fasten hose nipple.
2, When assembling machine, check clearance between drill shank and fixing sleeve, hold handle and force pressure to it slowly, ensure that work normally.
3, Oil machine every 2-3 hours(3-4.5° E50 turbine oil)
4, Do not insert the whole machine into ledge, when drilling incompetent bed.
5, When machine was jammed at crevice, do not drawout it powerfully, it will damage machine.
6, If dirt block strainer, romove it. Cannot disassemble strainer.
7, When using machine, dismantle it at least twice a week, use diesel oil to clean and dry, then oil, later assemble and operate machine.
8, If machine should be stored for along time, dismantle and clean it, then oil and store.
Audited Supplier 
){kind=link}